Robert Fripp — £500 · Sweet Spot Rig

• The Les Paul's humbuckers push a Marshall DSL into breakup much faster than single coils — start the amp's channel volume at 5 before going higher. The difference between 5 and 7 on a Marshall with a Les Paul is dramatic
• Delay in the effects loop of the Marshall DSL (after the preamp) produces cleaner repeats — the delay sees the amplified, saturated signal and repeats it as-is. Delay in front of the amp means each repeat gets re-amplified differently, which can sound thick but messy
• The neck tone knob rolled back to 6-7 gives a warmer, rounder sound that sits better in a mix than full-on brightness
• Volume above 4 on a boutique clean amp in a small room will be very loud — these amps are designed for stage use and the tone at correct volume is very different
• Kick in the boost only for solos or moments needing extra presence — the contrast between boosted and non-boosted creates dynamic structure in the song
• Mix level matters more than repeat count — 2-3 repeats at correct mix level is more musical than 8 repeats at low mix
• Reverb at the end of the signal chain (last in the chain or in the effects loop) produces cleaner, more defined spatial sound

• ✗Not exploring the Marshall DSL alone before adding pedals — a Les Paul or humbucker guitar into a British amp is already a near-complete overdrive system. Adding drive pedals on top is often unnecessary and muddies the amp's natural character
• ✗Ignoring the individual pickup volume and tone controls — the two-pickup switching options on a Les Paul give you four distinct tones within a single setting. Most players only use two.
• ✗Running multiple pedals into the input — boutique amps are designed for the natural guitar signal. Too many pedals before the input changes the input impedance and alters the amp's response.
• ✗Setting the boost level too high relative to the base tone — a boost for solos should raise the presence of the guitar, not cause a volume jump that overwhelms the mix. Level matching matters.
• ✗Not setting delay to song tempo — a delay that doesn't match the song tempo creates a rhythmic clash that builds and becomes increasingly obvious. Tap the tempo every time.
• ✗Ignoring the room or PA system — prog guitar changes tone dramatically in different acoustic environments. Dialling in EQ in isolation gives a different result than through a full PA.
• ✗Adding too many pedals — complex rigs with multiple switches require full attention to operate. Start with less and add only when a specific gap is identified.

Custom guitars through Frippertronics tape delay loops — Fripp's King Crimson work and solo ambient pieces use unconventional technique, new standard tuning and layered loops for a completely unique sonic identity.